From BTnodes - A Distributed Environment for Prototyping Ad Hoc Networks

Projects: FlashImagesForTargets

JAWS - Ready-to-use Flash Images for Various DSN Targets

Blink applications (visual flash verification)

targetsuperslow blinkblinkfast blink
tmote blink.tos2.tmote.hexblinkfast.tos2.tmote.hex
tinynodeblinksuperslow.tos2.tinynode.hexblink.tos2.tinynode.hexblinkfast.tos2.tinynode.hex
mica2 blink.tos2.mica2.hexblinkfast.tos2.mica2.hex

Demo applications for the BTnode target

HexfileDescription
uart-echo.20061218.btnode3.hexechoes incoming bytes and signals a received byte with a led pattern
senso.20061218.btnode3.hexuses of teco particles ssmall sensor to print out microphone and light values (if they exceed a certain threshold)
mhop_blink.20061218.btnode3.hexsends "blink" commands to an arbitrary node in a connected network by using the multi-hop transport layer and the connection manager
bt-cmd.20061218.btnode3.hexprovides a simple but powerful terminal interface to Bluetooth

Demo applications for the Tmote target

TmoteDsnTestApp.20061218.tos2.tmote.hextcmd blink
tcmd get voltage
tcmd get rx
tcmd get tx
DsnEchoTestApp.20070301.tos2.tmote.hexFor target board testing
Logs repeatedly messages and echoes successful target commands
LED 0 is set on boot up, LED 1 toggles on a command reception and LED 2 toggles each 5 seconds when a message is sent
ResetTest.20070112.tos2.tmote.hexAt startup (or after reset), all leds are turned on for a second. After that, the node starts blinking one led
Intended for testing Tmote resets, when resetting the DSN node

Demo Application for TinyNode target

tinynode_9600_printf_TOS1.tar.gz 
DsnEchoTestApp.20070301.tos2.tinynode.hexFor target board testing
Logs repeatedly messages and echoes successful target commands
LED 0 is set on boot up, LED 1 toggles on a command reception and LED 2 toggles each 5 seconds when a message is sent
Retrieved from http://www.btnode.ethz.ch/Projects/FlashImagesForTargets
Page last modified on March 01, 2007, at 03:21 PM