JAWS - Ready-to-use Flash Images for Various DSN Targets
Blink applications (visual flash verification)
target | superslow blink | blink | fast blink |
---|---|---|---|
tmote | blink.tos2.tmote.hex | blinkfast.tos2.tmote.hex | |
tinynode | blinksuperslow.tos2.tinynode.hex | blink.tos2.tinynode.hex | blinkfast.tos2.tinynode.hex |
mica2 | blink.tos2.mica2.hex | blinkfast.tos2.mica2.hex |
Demo applications for the BTnode target
Hexfile | Description |
---|---|
uart-echo.20061218.btnode3.hex | echoes incoming bytes and signals a received byte with a led pattern |
senso.20061218.btnode3.hex | uses of teco particles ssmall sensor to print out microphone and light values (if they exceed a certain threshold) |
mhop_blink.20061218.btnode3.hex | sends "blink" commands to an arbitrary node in a connected network by using the multi-hop transport layer and the connection manager |
bt-cmd.20061218.btnode3.hex | provides a simple but powerful terminal interface to Bluetooth |
Demo applications for the Tmote target
TmoteDsnTestApp.20061218.tos2.tmote.hex | tcmd blink tcmd get voltage tcmd get rx tcmd get tx |
DsnEchoTestApp.20070301.tos2.tmote.hex | For target board testing Logs repeatedly messages and echoes successful target commands LED 0 is set on boot up, LED 1 toggles on a command reception and LED 2 toggles each 5 seconds when a message is sent |
ResetTest.20070112.tos2.tmote.hex | At startup (or after reset), all leds are turned on for a second. After that, the node starts blinking one led Intended for testing Tmote resets, when resetting the DSN node |
Demo Application for TinyNode target
tinynode_9600_printf_TOS1.tar.gz | |
DsnEchoTestApp.20070301.tos2.tinynode.hex | For target board testing Logs repeatedly messages and echoes successful target commands LED 0 is set on boot up, LED 1 toggles on a command reception and LED 2 toggles each 5 seconds when a message is sent |